Osha Flat Roof Fall Protection Requirements

Osha defines what fall protection is required based on how close employees are to the edge of the roof.

Osha flat roof fall protection requirements.

Fall protection systems and other equipment they will be using on the job. Employers are to ensure. With regard to fall protection requirements applicable to the construction work itself 1926 501 b 10 low slope roofs requires conventional fall protection a combination of a monitoring system and warning line or on roofs of 50 feet or less in width a monitoring system alone i e without a warning line be used. When the fall protection measures listed above are not used mark the edges of the flat roof with headers and warning lines to notify workers of potential fall hazard areas using the following guidelines.

Supervise workers to ensure fall. Subpart m 1926 501 b 10 of the osha construction standards specifies that under certain conditions roofing work can be conducted with a warning line in place 6 feet from the edge and a safety monitoring system. If there is a fall risk it needs to be addressed. Lay headers sheets of roofing or other materials no closer than 5 feet inside the edges of the roof and parallel to the roofline.

Employers are to ensure that each employee is protected from falling by using fall. Except as otherwise provided in paragraph b of this section each employee engaged in roofing activities on low slope roofs with unprotected sides and edges 6 feet 1 8 m or more above lower levels shall be protected from falling by guardrail systems safety net systems personal fall arrest systems or a combination of warning line system and guardrail system warning line system and safety net system or warning line system and personal fall arrest system or warning line system and. Less than 6 feet from the roof edge. Understand the requirements of osha s fall protection standards at 29 cfr 1926 subpart m to protect workers exposed to falls six feet or more above a lower level.