Using spray foam insulation in an unvented attic application.
Open or closed cell foam for attic.
Lstiburek says to do it for every spray foam attic.
Most open cell foam has a density of about 5 pounds per cubic foot.
There is 300 difference there but the cost they give you is about a third difference and open cell foam at 12 inches will not give you the performance of 2 inches of closed.
These two types of spray foam insulation both contain polyurethane that can be potentially dangerous to the environment and to health upon exposure.
There you have it.
The myth that open cell is more economical is bullshit.
Closed cell foam can be over three times that with a density of 1 75 pounds per cubic foot or more.
Closed cell foam is much denser than open cell foam.
I have open cell in my house since 2004 and i would not use it in a dogs out house.
Open cell should be at least 6 inches in depth and closed cell 4 inches or more of each depending on local code.
A foams r value is its resistance to heat flow or in other words how well they insulate.
Light density open cell spray foam insulation and medium density closed cell spray foam insulation.
If you do not use the attic for a habitable purpose you might want to keep your thermal barrier on the floor of the attic.
While the denser closed cell variety does not readily absorb moisture open cell foam can draw it in like a sponge.
Both low density open cell and medium density closed cell spray foam can be used in an unvented attic to provide the needed thermal resistance and airtightness.
This type of spray polyurethane foam can be classified into two different types.
Open cell foam has an r value of about 3 5 to 3 7 per inch while closed cell foam has an r value of about 6 per inch.
Open cell spray foam is a perfectly acceptable insulation product to use in attics.
Do it right and your roof will not rot.
Open cell foam weighs 1 2 pound per cubic foot and closed cell weighs 2 lbs per cubic foot.